Reaction Injection Molding (RIM) can produce strong, flexible, lightweight parts which can easily be painted. It also has the advantage of quick cycle times compared to typical vacuum cast technique. The bi-component mixture injected into the mold has a much lower viscosity than molten thermoplastic polymers, therefore large, light-weight, and thin-walled items can be successfully RIM processed. This thinner mixture also requires less clamping forces, which leads to smaller equipment and ultimately lower capital expenditures.
The reaction injection molding we offer at Honkia has varying wall thickness on various parts to increase the efficiency of the device. Our RIM tooling is usually 70% cheaper with its conventional PIM molds and the RIMed parts have lightweight structural without any sink. It can mold over ABS, aluminum, epoxy, silicone rubber, glass, wood, wiring, circuit boards, hardware, etc. In case you are trying to opt for an economic solution lower volume parts, reaction injection molding is the right choice as it features lower high-volume per-part cost.
Honkia offers you various reaction injection molding parts. We, at Honkia are respected in the industry because of our dedication to provide the quality material, cheap and rapid tooling, fast turnaround to clients. The RIM service we send out to global market are quick, economical and quality that are proven by the customers used our service, especially from automobile field. We look forward to do more and better by our continuously improving RIM expertise and experience.